Purchase this item and get Description
UHMW Cutting Edge Attachment Hardware
Purchase the hardware (nuts, bolts, and washers) required to attach your 6 x 1.25″ UHMW Cutting Edge to your HLA Snow Pusher.
Bolts are 5/8 x 3″.
The quantity of hardware you’ll need is pre-selected based on the width of your Snow Pusher. Each HLA Snow Pusher has pre-drilled holes for a cutting edge and back drag, so you just use those as your bolt guides for your piece of UHMW.
How To Install Your UHMW Cutting Edge
- Clamp It
- Drill It
- Tighten It
All you need to do is clamp the cutting edge in place along the Snow Pusher, then drill a 5/8″ hole through the UHMW using the pre-drilled holes in the Snow Pusher as your guide. Then tighten down the bolts and you’re good to go.
Remember, when one side of your UHMW wears down, you can reverse it and use the other side, effectively getting twice the longevity from a single piece.
Hardware Quantity Requirements
These are the number of sets of hardware you need for 6 x 1.25″ UHMW on the following width of Snow Pushers. But don’t worry, we’ve already matched up the quantity and the width in the purchase options.
- 54” Requires 5 Sets
- 60” Requires 7 Sets
- 66” Requires 6 Sets
- 72” Requires 8 Sets
- 84” Requires 9 Sets
- 96” Requires 10 Sets
Reviews
There are no reviews yet.